12 FASTBACK 9 USER’S MANUAL, 203860 Rev. A
BINDING A DOCUMENT
WITH Lx-CP STRIPS™
VI-C
1. Set the binder to LX CP mode. If the machine is in LX CP
mode, the display will read “READY TO BIND” … “LX CP.”
2. Select your Lx-CP Strip according to your document
thickness:
10-125 sheets= Narrow
125-250 sheets = Medium
(This may vary slightly depending on the paper and cover thickness.)
HINT: If you are not sure which strip width to use, simply
place your document in the binding recess and push the
BIND button. The correct width will be shown on the
display.
3. Foldthestriptoa90°angle(gure18a).Makesurethe
adhesive side faces inward.
4. Place the strip into the binding recess with the adhesive
side facing up. The short side of the bent “L” should be
resting against the back wall. Slide the strip all the way to
theright(gure18b).
HINT: For a uniform strip wrap width on your front
cover—regardless of document thickness—turn your
document in the binder with the front cover facing the
back of the machine.
5. Tampyourdocumentcoverandpagesonthefrontat
surface of the housing so that they are straight. Place the
document on top of the strip and slide the document all the
waytotheright(gure19).
6. Tap the document on the top and the left to be sure all
pages are even. Push the pages backward to ensure proper
binding. Check that the document edge aligns with the edge
ofthestrip(gure20).
7. PresstheBINDbutton(gure21).Thebindingprocesswill
begin.
•
NOTE: Stoppingthebindingprocess:Duringtherst
several seconds of the binding cycle, you can push the
OPEN button (the orange button closest to the front) to
abort the whole process and open the document clamps.
Use a new binding strip when the process resumes.
8. Assoonasthedisplayashes“REMOVEBOOK,”pickup
the document and place it against a rear book support
fence(gure22).
9. Letthebounddocumentcoolforveminutes.
•
NOTE: The Lx-CP strip is intended for used with either
endleaves (if you are making a hard cover book), or
cover sheets (e.g., Comp Cover or Clear Cover). Binding
coverless books with the Lx-CP strip is not recommended.
F I G U R E 18a
F I G U R E 18b
F I G U R E 19
F I G U R E 20
F I G U R E 21
F I G U R E 22
EDNord - Istedgade 37A - 9000 Aalborg - telefon 96333500
Comments to this Manuals