EDNord QMS magicolor Installation Guide download pdf (Page 13)





 



 Your printer requires a properly grounded AC outlet with a rated line voltage of 100

V, 120 V, or 220/240 V.

 The line voltage must remain within ±10 percent of the rated voltage for proper

operation of the printer.

 The amperage capacity of the electrical outlet must be at least 1.2 times that used

by the printer.

 The maximum electrical current required during operation is 10 amps for a 100 V

system, 8.3 amps for a 120 V system, and 4.5 amps for a 220/240 V system.

 Noise-generating equipment should not be connected to the same electrical outlet

as the printer.

 The recommended frequency is 50–60 Hz ±2 Hz for a 100 V system, 60 Hz ±2 Hz

for a 120 V system, and 50 Hz ±2 Hz for a 220/240 V system.





Printer performance depends upon the type of computer to which you connect it. We

recommend a Pentium-class computer with at least 16 MB of RAM (if you’re using

Windows 95/98) or 32 MB of RAM (if you’re using Windows NT 4.0).

The QMS

magicolor

2 DeskLaser is compliant

with US Environmental Protection Agency (EPA)

Energy Star regulations. After a specified period

of inactivity, the printer changes to a low-power

state (the engine remains on, but the fuser turns

off). When a print job is received, the printer

returns to normal power within a user-config-

urable time period.

EDNord - Istedgade 37A - 9000 Aalborg - telefon 96333500

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 59 60

No comments

EDNord QMS magicolor Installation Guide Page 13